INLET MANIFOLD MOPED DOPPLER OPEN I_3D FOR MBK FXC/51/ENGINE AV10 (FLEXIBLE MOUNTING)

Made by 3D printing using powder sintering. This process allows for an optimum shape of the intake pipes.

Inventory of the different parts :
- 1 pipe
- 4 screws (same number as the fixing point)
- 4 washers (same number as the fixing point)
-1 sleeve

WARNING: the material used is sensitive to tightening, it is imperative not to exceed the tightening torque (4Nm), and not to forget to use the washers supplied. In the case of an incomplete seal, use sealing compound rather than excessive tightening of the screws, which would cause deformation of the base.

• MBK 51 V (50 cc)
• MBK MAGNUM RACING (50 cc)
• MBK MAGNUM RACING XR (50 cc)